Caframo BDCMN003 Mode D'emploi page 6

6. All mixing paddles and impellers must be in good condition with straight
shafts. If the stirrer vibrates at high speeds check the paddle shaft for
damage and repair or replace it.
7. Extreme care must be taken when mixing chemicals so that no chem-
icals are splashed outside the mixing vessel. Care must be taken when
changing to faster mixing speeds. On power up, the stirrer will display
its set speed and will ramp to that speed when the start/pause button is
pushed. Always start at lowest speed if unsure of maximum safe speed.
8. Ensure that the mixing impeller does not contact the vessel.
9. Do not operate while standing in water. Keep the stirrer dry and do not
immerse any part, except the mixing paddle, into any liquids.
10. Ensure that no loose clothing, jewelry, or hair can become entangled in
any rotating parts. A fast spinning chuck can cause injury to an operator.
Use chuck guard provided when stirrer is in use.
11. Ensure the power button and mains power cord of the stirrer can be ac-
cessed immediately, directly and without risk at any time, and above all,
in case of fault.
12. Shaft rotation can be stopped by pressing the start/pause button or power
button. This does not disconnect power to the stirrer's internal drive cir-
cuit. In an emergency, power can be interrupted by disconnecting the
mains cord.
13. Wear appropriate personal protective equipment such as eye protection
and any clothing suitable for the application.
14. Repairs must be carried out only by technicians authorized by Caframo.
15. Stirrer must be used with supplied power cord(s). The cord(s) and ground-
ed plug types are important safety elements. Always connect the stirrer to
a grounded outlet. Do not alter the plug.
4