Dimensions; Installation; Chuck Removal And Attachment; Impeller Attachment - Caframo BDCMN003 Mode D'emploi

Dimensions

207.5
101.5 mm
1907 mm
[8.2 in]
.
[4.0 in]
[75.0 in]
148.8 mm
284.1 mm
[5.9 in]
50.7 mm
233.4 mm
[11.2 in]
[2.0 in]
[9.19 in]
37.0 mm dia.
[1.5 in]

Installation

The stirrer must be securely fixed to a stable support - e.g. clamped to an original
Caframo stand that is on a stable, level surface. See Safety Instructions.

Chuck removal and attachment

Align chuck set screw with pilot hole on the motor shaft. Slide chuck onto motor
shaft. Tighten the set screw using the hex end of the provided chuck key.

Impeller attachment

Open the chuck fully using the provided chuck key. Insert the impeller shaft into
the open chuck and adjust the impeller to the desired height. The hollow shaft al-
lows the impeller shaft to come through the top of the stirrer if necessary. Tighten
the chuck's outer ring by hand and then secure with the chuck key using all three
insertion points.
8