Faber Tratto Isola Instructions D'installation page 9

DUE TO THE SIZE AND WEIGHT OF THIS RANGEHOOD, THREE PEOPLE ARE REQUIRED TO INSTALL THE CANOPY.
Two people must hold the canopy in place while the third person installs the screws that attach the canopy to the chimney.
The manufacturer assumes no responsibility for injury or damage caused by improper installations.
4. From below, attach the CANOPY SECTION (A in FIGURE
12) to the assembled chimney support using the four bolts
provided (E in FIGURE 14).
MAKE THE INTERNAL ELECTRICAL CONNECTIONS
5. Connect the CONTROL CABLES together as indicated in
A in FIGURE 15. Insert the connected CONTROL CABLES (A
in FIGURE 15) into the black plastic CONNECTOR BOX (B in
FIGURE 15) by connecting the two black plastic pieces using
the four screws provided.
A
FIGURE 15
!
FIGURE 14
A
B
WARNING
For ductless installations, install the CHARCOAL FILTER (F in
FIGURE 12) behind the center grease filter opening by inserting
and locking into place. (See FIGURE 16)
6. Remove the grease filters from the unit and set aside. The
grease filters are installed by pressing the handle in front of the
filter (FIGURE 17). When replacing, make sure that the filters
are properly positioned with the handles in front and visible.
7. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker is
not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
FIGURE 16
FIGURE 17
Version 02/12 - Page 9