Table des Matières
Publicité
Elektrischer Anschluss
Connections provided by the customer at connection plate MST5
Terminal 1:
Terminal 2:
Terminal 13: OPEN
Terminal 14: CLOSE
Terminal 4:
Terminal 3:
Terminal 12:
Electrical connection
Holds the protective conductor witch is used -as indicated by the
name- for protective function only. All conductive parts are
thereby connected to ground.
Holds the neutral conductor to provide for current flow, if
necessary.
If the control voltage will be applied to terminal no. 13, effects this
a rotation to position OPEN : at clockwise - actuators standard.
Looking onto the shaft from 12.00 o'clock to 03.00 o'clock.
At anticlockwise actuators the rotation affects to the other side.
Looking onto the shaft from 12.00 o'clock to 09.00 o'clock.
If the micro switch S2 will be pressed via the actuating cam, or the
voltage at terminal no. 13 will be disconnected, the rotation stops.
If the control voltage will be applied to terminal no. 14, effects this
a rotation to 12.00 o'clock, position CLOSE : (delivery status)
at clockwise - actuators standard.
Looking onto the shaft from 03.00 o'clock to 12.00 o'clock.
At anticlockwise actuators the rotation affects to the other side.
Looking onto the shaft from 09.00 o'clock to 12.00 o'clock.
If the micro switch S1 will be pressed via the actuating cam, or the
voltage at terminal no. 14 will be disconnected, the rotation stops.
WARNING
It is not possible to have, at one time, voltage applied
to both terminals 13 and 14!
If switches S1 is actuated and voltage applied to terminal no. 14,
terminal 4 provides a voltage which can be used for control
purposes
If switch S2 is actuated and voltage applied to terminal no. 13,
terminal 5 provides a voltage which can be used for control
purposes.
L1 manual, attached at this terminal a tension can the drive by
means of the two tracers on the plate be proceeded by hand
(optionally)
Kap. 4
Raccordement électrique
Publicité
Table des Matières
