HIKVISION DS-2DYH2A0IXS-D Guide De Démarrage Rapide page 5

restrictions applied to the location and
about any precautions that shall be taken.
Installation
Install the equipment according to the
instructions in this manual.
Make sure that the power has been
disconnected before you wire, install, or
disassemble the device.
Transportation
Keep the device in original or similar
packaging while transporting it.
Do not drop the product or subject it to
physical shock.
Power Supply
Refer to the device label for the standard
power supply. Please make sure your
power supply matches with your device.
Install blackouts equipment into the
power supply circuit for convenient supply
interruption.
System Security
Please understand that you have the
responsibility to configure all the
passwords and other security settings
about the device, and keep your user
name and password.
Maintenance
If the product does not work properly,
please contact your dealer or the nearest
service center. We shall not assume any
responsibility for problems caused by
unauthorized repair or maintenance.
Cleaning
Please use a soft and dry cloth to clean
the interior and exterior surfaces. Do not
use alkaline detergents.
Using Environment
When any laser equipment is in use, make
sure that the device lens is not exposed to
the laser beam, or it may burn out.
Do not aim the lens at the sun or any
other bright light.
To avoid heat accumulation, good
ventilation is required for a proper
operating environment.
DO NOT expose the device to extremely
hot, cold, dusty, corrosive, saline-alkali, or
damp environments. For temperature and
humidity requirements, see device
specification.
DO NOT expose the device to high
electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the
device, immediately turn off the power,
unplug the power cable, and contact the
service center.
Time Synchronization
Set up device time manually for the first
time access if the local time is not
synchronized with that of the network.
Visit the device via web browser/client
software and go to time settings interface.
1 Overview
1.1 Appearance
Figure 1-1 Appearance
Table 1-1 Appearance Description
No. Description
1 Housing
2 Wiper
3 Main Body
1.2 Cable Descriptions
Refer to the labels attached on the cables
for function identification.
Figure 1-2 Cables
Table 1-2 Cable Description
No. Description
1 Power
Cord
2 RS-485
Cable
Notes:

Make sure the positive and negative
poles of the power adapter are
correctly connected to the device.

The yellow/green cable of the power
adapter must be connected to that
of the power cord to ensure good
grounding. Otherwise, electric shock
may occur.
1.3 Alarm Input/Output
The device can be connected to the alarm
signal input and switch output. It can
trigger video recording, preset calling, and
switch output, etc.
Figure 1-3 Alarm Cables
3
No. Description
4 Base
5 Rain Sensor
No. Description
3 Audio and
Alarm
4 Network
Cable