JVC VN-C215V4U Guide Rapide page 12

Introduction
Name and Function of Parts
(continued)
Inside the camera
Lens section
(A Pg. 13)
J
K
L
M
N
Q
Ceiling Mount Bracket (x3)
This serves as a bracket when embedding the
camera in a ceiling. (A Pg. 17)
R
Camera Fastening Screw
This secures the camera unit N and the outer
case C. How to remove (A Pg. 18, 20)
S
Pan fastening screw
Make sure you loosen the screw before setting.
Only tighten the screw when using the camera in
locations with vigorous vibrations so that the
camera shooting direction is not misaligned.
(A Pg. 28)
T
Imaging Direction mark
Install the camera facing the arrow in the
shooting direction.
U
Rotation Knob
This knob rotates the lens sections and adjusts
the tilting of the image. (A Pg. 28)
V
Rotation center mark
(A Pg. 28)
E-12
W
V
U
T
S
R
Q
P
W
Tilt fastening screw
After adjusting the field angle, tighten the screw
so that the camera field angle will not be
misaligned when using the camera in locations
with vigorous vibrations. (A Pg. 28)
X
Fall-prevention wire mounting hole and
screw
This is used to mount the fall-prevention wire
from the ceiling.
(The fall-prevention wire is not supplied.)
Y
[MAC address] MAC address indicator
The MAC address is a unique physical address
of the product. This address cannot be altered.
Behind the camera unit
O
P
Y
MAC address
X