Changing Control Settings; Updating Firmware - Ovention F1400 Manuel D'installation Et D'utilisation

OPERATION

Changing Control Settings

Use the following procedure to make changes to control access
privileges and oven operation.
1. Touch the icon on the Menu Screen. A password
screen will appear.
• Enter the 3-digit password
"248". The Service screen will
appear.
2. Touch CONTROL on the Service
screen. The Control Settings
screen will appear.
3. Make the desired adjustments on the Control Settings
screen.
• Passcode: Touch ON to require
a password to make changes
to oven settings. Touch OFF to
disable this setting.
• ColorGuard: Touch ON to use
the ColorGuard System. Touch OFF to disable the
ColorGuard System.
• Belt: Touch L to have the conveyor belt direction move
from left-to-right. Touch R to have the conveyor belt
direction move from right-to-left.
4. When all changes are done, touch EXIT to return to the
Service screen, then EXIT again to return to the Menu
Screen.

Updating Firmware

Use the following procedure to upload
firmware updates to the toaster from an
external USB drive.
Service
Firmware Usage
Control FactoryTest
SystemInfo PowerSave
Version Exit
Control Settings
Passcode On Off
ColorGuard On Off
Belt L R
EXIT
10
1. Follow the "Startup" procedure
listed previously in this section.
2. Touch the icon on the Menu
Screen. A password screen will
appear.
• Enter the 3-digit password "248".
The Service screen will appear.
3. Touch FIRMWARE on the Service
screen. The Update Select screen
will appear.
4. Touch FIRMWARE on the Update
Select screen. The Firmware
Update screen will appear.
5. Slide the cover to the side, and
insert the USB drive into the USB
port.
• The USB port is on the side of
the unit, next to the Power I/O
switch.
6. Touch UPDATE.
• The firmware update will begin
and last approximately 30
seconds (a progress bar will
appear). NOTICE: Do not
remove the USB drive or turn
off the unit during a software
update.
• When the update is complete, the unit will restart and
the Logo screen will appear for a few seconds showing
the new firmware version.
7. Remove the USB drive from the USB port, and slide the
cover back to cover the port.
English
Power I/O
Switch
USB Port
Service
Firmware Usage
Control
FactoryTest
SystemInfo PowerSave
Version Exit
Firmware
Exit
Firmware Update
Plug-in the USB stick, then
press the Update button.
Update
Exit
OVFM-0422