Assembling The Handles - SNOWJOE 24V-X2-20SB-CT Manuel De L'opérateur

IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to
the batteries.
6. When charging is complete, remove the batteries from the
charger by pulling the push lock button and sliding the
batteries backward to unlock it from the charger.
Charging a Hot or Cold Battery Pack
The green indicator lights on the charger base indicates that
the battery pack temperatures are outside the charging range.
Once the pack are within the acceptable range, normal
charging will take place and the red light will be continuous.
Hot or cold battery packs may take longer to charge.
Assembly

Assembling the handles

1. Mount the middle handle frame onto the lower handle
frame and align the holes. Join the handle frames with 2
sets of handle frame latches + threaded connectors as
shown (Fig. 4).
NOTE: When threading the connector, make sure the
latches are flipped down in the unlocked position as
shown.
Fig. 4
Middle handle frame
Lower handle frame
Latch Washer Threaded
connector
2. Secure with latches and connectors, then flip up latch to
lock the frame assembly in place (Fig. 5).
Fig. 5
Flip up to lock
3. Follow the same instructions above to fit and secure the
upper handle frame onto the middle handle frame with the
other latch + threaded connector set (Fig. 6).
Fig. 6
Middle
handle
frame
4. Use the clips to secure the cable during operation. Insert
the cable into the cable clips, and attach to the handle
frame as shown (Fig. 7).
Unlocked
position
(Flipped
down)
10
Upper handle
frame
Handle frame latch +
threaded connector
Fig. 7
Cable clip