Assembling The Handles - SNOWJOE iON18SB Manuel D'utilisation

7. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger (Fig. 4).
Fig. 4
Push lock button
8. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the battery.
Charging a Hot or Cold Battery Pack
A red and green flashing indicator light on the charger indicates
that the battery pack temperature is outside the charging
range. Once the pack is within the acceptable range, normal
charging will take place and the red light will be continuous.
Hot or cold battery packs may take longer to charge.
Lithium-Ion Charging Status
Battery Pack Red Charger
Temperature Indicator Light
Too hot Flashing
Normal range Continuous
Too cold Flashing
Assembly

Assembling the handles

1. For easy assembly, the snow blower comes equipped with
most of the parts already connected. In just a few simple
steps, your snow blower will be ready to go. To engage the
handle, pull up on the upper frame (Fig. 5).
Fig. 5
2. Secure the connection of the middle handle assembly to
Fig. 6
Charging
Status
3. Secure the connection of the middle handle assembly
Not charging
Normal charging
Not charging
Fig. 7
10
the upper handle by fastening the handle locks on each
side (Fig. 6).
to the lower handle using 2 handle knobs and 2 square
J-bolts and tighten on each side (Figs. 7 & 8).