SNOWJOE 24V-X2-20SB-CT Manuel De L'opérateur page 8

Technical Data
Motor ........................................................... 1000 W Brushless
Battery Voltage Max* .................................... 48V D.C. (2 x 24V)
No Load Speed ............................................... 2300 ± 100 rpm
Auger .................................................... 2 blades paddle auger
Clearing Width .................................................. 20 in. (50.8 cm)
Depth of Snow Cut ........................................... 10 in. (25.4 cm)
Throw Distance Max ................................................. 20 ft (6 m)
Plowing Capacity Max ....................... 800 lbs/min (363 kg/min)
Stages .................................................................. Single stage
Type of Snow ........................................................... Light, fluffy
Directional Control ................................ 180º auto-rotate chute
LED Light ................................................................... 3 W each
Tire size .................................................................. 7 in (18 cm)
Net Weight ..................................................... 33.6 lbs (15.3 kg)
* Generates 48 V max with two 24 V lithium-ion batteries. Initial no-load voltage,
per fully charged battery, peaks at 24 V. Nominal voltage under typical load
is 21.6 V.
Unpacking
Carton Contents:
• Cordless snow blower
• Middle handle frame
• Upper handle frame
• Discharge chute assembly
• Discharge chute screw
• Handle frame latch + thread connector sets (4)
• Hex key wrench
• Cable clips (2)
• Crank rod
• Crank rod cotter pin
• Manual with registration card
NOTE: In order to operate this cordless snow thrower you will
need iON+ 24V System batteries and chargers. See page 17 for
battery options and specifications, or visit snowjoe.com.
1. Carefully remove the cordless snow blower and check to
see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the electric snow
thrower. The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations or save the packaging for long-term
product storage.
customer service center at
®
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suffocation risk!
Battery Pack Operation
The equipment is powered by 2 lithium-ion batteries. The
battery packs are completely sealed and maintenance free.
TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless snow blower you will
need two batteries and one charger from the iON+ 24V
System. See page 17 for battery and charger options and
specifications, or for more information visit snowjoe.com.
m
WARNING!
The cordless snow blower can only be
powered by both of the batteries together. One battery cannot
provide sufficient power to the tool. Make sure to use two
batteries of the same voltage and the same capacity. Using the
tool with batteries of different capacity will cause damage to
the batteries.
Battery Charge Level Indicator
The battery packs are equipped with a push button for
checking the charge level. Simply press the push button to
read off the battery charge level from the LEDs of the battery
indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery's service life will be greatly shortened.
Lights Light Indicators
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
NOTE: If the charge level button does not appear to be working,
place the battery pack on the charger and charge as needed.
NOTE: Immediately after using the battery packs, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells "recover" some of their
charge after resting.
8