V2 CITY2+ Mode D'emploi page 44

PARAMETER VALUE
CoS1
no
AP
APCh
CoS2
no
Ch
APCh
Co.tE
no
Foto
rESi
FC.En
no
L.SW
Cor.0
EnCo
no
Si
i.Adi
no
Si
DESCRIPTION
Safety ribbon 1 input
This menu allows enabling the input for type 1 safety ribbon, that is to say,
fixed ribbons
Input disabled
Input enabled during the opening and disabled during the closure
Input enabled in opening and closure
Safety ribbon 2 input
This menu allows enabling the input for type 2 safety ribbon, that is to say
mobile ribbons
Input disabled
Input enabled during the closing and disabled during the opening
Input enabled in opening and closure
Test of the safety edges
This menu allows setting the method of control of the safety edges
working.
Test disabled
Test enabled for optical safety edges
Test enabled for conductive rubber safety edges
End of Stroke Inputs
End of stroke inputs are disabled
End of stroke equipped with a normally close switch
End of stroke in series of motor winding
Encoder Input
Input disabled
Input enabled
Enabling the ADI device
This menu makes it possible to enable operation of the device connected
to the ADI connector.
Si
PLEASE NOTE: selecting
and pressing MENU accesses the
configuration menu for the device connected to the ADI connector.
This menu is managed by the device itself and is different for each device.
Please refer to the manual for the device.
Si
If the option is selected, but no device is connected, the display will
show a series of dotted lines.
Exiting the ADI device configuration menu returns to the
Interface disabled
Interface enabled
i.Adi
- 42 -
DEFAULT MEMO
no
no
no
no
no
no
option