Cleaning And Maintenance; Installing The Wall Bracket; Environment Friendly Disposal - Sinbo SHB 3029 Mode D'emploi

2. You can wash the removable shaft under water without using abrasive
cleaning agents or detergent. Turn the shaft upside down upon cleaning
to drain off the water.
This part is dishwasher safe.
3. Wash the bowl, cup, beater and blade in warm soapy water.
Since the plastic components of the bowl and beater can be deformed in
dishwasher, it is not recommended to wash them in dishwasher.
4. Wipe the motor unit with a damp cloth. Never immerse the motor unit
in water to prevent the risk of electric shock.
5. Dry the unit thoroughly.
Warning: Blades are very sharp, handle carefully.
6. Assemble the blender shaft to the motor unit again and place it on the
wall mounted bracket upside down (Figure 4) or hang it to save space.
QUICK CLEANING
Between processing steps take the handheld blender set and immerse in a cup filled
with water up to its half and operate for a few seconds.

INSTALLING THE WALL BRACKET

You can install the wall bracket as follows:
1. Drill two identical holes in the wall observing the dimensions
indicated in figure 5.
2. Place the two plastic dowels inside the holes using a hammer.
3. Fix the wall bracket using two screws.

ENVIRONMENT FRIENDLY DISPOSAL

You can contribute to environmental protection!
Please follow the local regulations: Take the inoperable electrical devices to
appropriate disposal centers.

CLEANING AND MAINTENANCE

- 12 -
Fig 4
Fig 5