Maintenance; Parts Drawing - GeneralAire 1000A Manuel D'installation

Table des Matières

Publicité

Model 1000 Humidifier Installation Manual

Maintenance

Your humidifier is engineered to give helpful and trouble-free humidification. For maximum efficiency the following
cleaning procedures should be carried out at the end of each heating season:
1. Turn off the water supply and electrical power to the humidifier.
2. Remove cover, water distributor trough, used Vapor Pad
deposits from the distributor trough, drain pan, pad rails and humidifier cabinet. A solution of 1/2 vinegar & 1/2
water will help loosen mineral deposits. Inspect drain hose, clean or replace as necessary.
3. Insert a new GA19 Vapor Pad
cover, reconnect electrical plug. Replace Vapor Pad
4. In heavy mineral areas or if the solenoid valve fails to function disconnect the 1/4" water supply line from the
solenoid valve. Carefully pull the strainer screen (GFI #7564) from the valve body. Clean the mineral deposits from
all parts. If the orifice is clogged, it may be opened by inserting a small pin. Reinsert the filter into the valve body.
5. Reconnect the 1/4" water line to the solenoid valve if necessary. Turn on the water supply and check all points for
leakage. The operation of the unit may be checked by starting the furnace. The humidifier operates only when the
furnace blower is running or the burner circuit is energized. The humidifier is now ready for operation.
6. During the summer, turn OFF the water supply and electrical power to the humidifier.

Parts Drawing

900-9 NOZZLE
900-10 SPOUT
8
Breathe Healthier!
Residential Whole-House Indoor Air Quality
(GFI# 7919; black notch on top). Install trough, pad rails and drain pan. Replace
®
yearly for peak performance.
®
900-40 PAD RAIL
GA19 EVAPORATOR PAD
900-15 DISTRIBUTOR TROUGH
GA4247 FAN BLADE
900-14 DRAIN PAN
GA4231 ORIFICE - YELLOW
P-190 COMPRESSION SLEEVE (PLASTIC)/P102 COPMRESSION SLEEVE (BRASS)
P-101 COMPRESSION NUT
GA4235 DISTRIBUTOR TUBE
P-189 TUBE SUPPORT
P-101 COMPRESSION NUT
P-102 COMPRESSION SLEEVE (BRASS) OR
P-190 COMPRESSION SLEEVE (PLASTIC)
GA4004 STRAINER SCREEN
GA4045 SOLENOID & HARNESS
ASSEMBLY
, pad rails and drain pan. Clean excessive mineral
®
GA4237 MOTOR
900-71 NAMEPLATE
1000-11 HARNESS - BOARD
GA4238 RELAY ASS'Y
1137-31 POWER SUPPLY CORD

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1000m57305735

Table des Matières