Fm Transmission Operation; Summary Of Functions And Button Operations; Led Indicator Patterns - Funkwerk EGO Cup FM Manuel De L'utilisateur

4.6.2. FM Transmission Operation

The EGO Cup FM has 6 different FM Channels, which have been stored to the following frequencies (factory setting): FM1:
87.50 MHz, FM2: 91.00 MHz, FM3: 94.50 MHz, FM4: 98.00 MHz, FM5: 101.50 MHz and FM6: 105.00 MHz. You can switch between
these channels, by pressing
Because of regional radio stations it may happen that the pre-selected frequencies are occupied and cannot be used for the
transmission to your car radio. In this case you can change the frequency of the channels as follows:
1. Please search with you car radio for a frequency that is not occupied by a radio station
2. Select the FM channel on the EGO Cup FM that should be used with another frequency.
3. Press the button for at least 6 seconds and keep it pressed. You will hear two tones and the display shows how the
frequency for this channel is increased. If you have reached the desired frequency please release the
4. To store this frequency please press
If you want to lower the frequency of a channel please follow the instructions above but instead of the
button.
Note:
Do not use FM Transmission during the charging, to avoid the radiation, crosstalk or static noise in the car radio.

5. Summary of Functions and Button Operations

5.1. LED Indicator Patterns

LED Pattern 1 – Standby mode:
LED Pattern 2 – Connect mode:
LED Pattern 3 – Call mode:
LED Pattern 4 – Pairing mode:
LED Pattern 5 – Low power warning:
LED Pattern 6 – Audio mode:
button (to choose next channel) or
.
Blue LED blinks once every 3 seconds
Blue LED glows dimly without blinking
Blue LED glows brightly without blinking
Blue LED blinks once every second
Red LED is ON and blue LED blinks once every 20 seconds
Blue LED glows brightly without blinking
English
button (to choose previous channel) for at least 3 seconds.
12
button.
button please press the