Speaker A : the [
Speaker B : the [
4. Both speakers are now connected and they are in pairing mode together.
Note : IF YOU HOLD BOTH BUTTONS TOO LONG THE SPEAKERS WILL POWER OFF. IF THIS HAPPENS TURN THEM
ON AGAIN AND RETRY STEP 3.
5. Set your mobile phone or other Bluetooth™ enabled device to search/scan for Bluetooth™ devices.
On an iPhone® :
Go to SETTINGS > BLUETOOTH (make sure Bluetooth™ is turned ON)
On an Android® Phone :
Go to SETTINGS > BLUETOOTH (make sure Bluetooth™ is turned ON)
6. When the Bluetooth enabled device finds the speakers, Select Freesound‐ST from the list of found devices.
7. If required, enter the password « 0000 ». Select OK or YES to pair the speakers.
8. After successful registration, the speakers will beep twice.
Speaker A : the [
Speaker B : the [
Note : WHEN YOU POWER OFF THE SPEAKERS (SEE « USING YOUR BLUETOOTH SPEAKERS ») THEY WILL
DISCONNECT FROM YOUR BLUETOOTH DEVICE. WHEN YOU TURN THEM ON AGAIN, SELECT FREESOUND‐ST
FROM YOUR DEVICE'S BLUETOOTH LIST TO RECONNECT THEM AGAIN.
The screenshots above are typical of many Bluetooth™ enabled devices. They are used to assist in the
explanation of pairing process. Your Bluetooth™ enabled device's interface and interaction with the
Bluetooth™ speakers may differ from the screenshots.
Pairing the speakers to two Bluetooth™ enabled devices :
Pairing the first speaker to a Bluetooth™ device :
1. Make sure both speakers are powered OFF.
2. Turn ON one speaker only (press and HOLD the [
3. The [
] button will flash BLUE. The speaker is now in pairing mode.
4. Set your mobile phone or other Bluetooth enabled device to search/scan for Bluetooth devices.
5. When the Bluetooth enabled device finds the speakers, select FREESOUND‐ST from the list of found devices.
©Copyright LOTRONIC 2015
] button will flash BLUE quickly.
] button will stay a steady RED.
] button will stay a steady BLUE.
] button will stay a steady RED.
] button for 3 seconds or until you hear beeps)
FREESOUND‐ST
3