BlueStork Ethernet RJ-45 200 Mbps Powerline TURBO Twin pack Manuel D'utilisation page 15

Your Powerline AV network is now protected against unauthorized access.
Join an existing Powerline AV Network
1. Press the Pair button on powerline adaptor C for more than 10 seconds until the Powerline light flashes.
2. Then repeat Steps 3 and Step 4 in this section using any powerline device (A or B) .
Pair Button Behavior
The following table summarizes the actions that occur when the Pair button is pressed for specific time.
Pair button
Action
less than 3
seconds
more than 10
seconds
Reset
To reset the Powerline AV device,
1.Make sure the Power LED is on and not blinking.
2.Press and hold the Reset button for lesss than three seconds. Release the Reset button when the Power
LED begins to blink. The default settings have been restored.
：
Status
The adaptor joins a network.
It shares the same network
name as other adaptors on
the powerline network.
The adaptor leaves
network it is associated with
and its network name
assumes a random value.
Ethernet Powerline Adaptor
Powerline Light Behavior
The Powerline light turns on
if your adaptor is connected
to another powerline adaptor
or a powerline network.
any The Powerline light turns off
when it disconnects from the
powerline network.
2