BlueStork Ethernet RJ-45 200 Mbps Powerline TURBO Twin pack Manuel D'utilisation page 14

Advance Feature:
Pair( Secure with 128 bits-AES)
The Powerline AV standard uses 128-bit AES (Advanced Encryption Standard) to safely transmit data
between powerline adapters. For the powerline adapters to communicate with each other they all need to use
the same Network Membership Key (NMK). Otherwise, they cannot unscramble the encrypted data sent in
the powerline network.
The Pair button allows you to set up a secure powerline connection with other HomePlug AV compliant
powerline devices which also support the Pair feature.
Set Up a Powerline AV Network with the Pair button
You can connect a number of devices on a powerline network, but you can use the Pair button on only two
devices at a time.
Create a Powerline network using the Pair button
Step 1.Place a powerline adaptor A close to another powerline device B . After you set up the first powerline
adaptor, you have 120 seconds to set up the second powerline device.
Step 2. Press the Pair button at one of your powerline adaptor A for more than 10 seconds until the Powerline
light is off. This resets the network name to a random value and removes your device from any
network it may belong to.
Step 3. Press the Pair button at the other of your powerline adaptor B you wish to connect for 2 seconds.
(This must be done within 120 seconds of pressing the Pair button on the first adaptor.)
Step 4. Wait for about 60 seconds while your powerline adaptors connect. The Powerline lights on both
adaptors turn on when the connection is made.
How to Use the Push buttons
：
Ethernet Powerline Adaptor 1