MTD OEM-190-180A Manuel De L'opérateur page 12

Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bagger support rail (1)
with the edge of the snap feature aligned with the red line,
as seen in the inset of Figure 4-11.
2. Snap the front side of the chute support to the rail (2), as
shown in Figure 4-11.
2
3. If not already done so by the factory, install the bagger
screen into the bagger cover by first inserting the end
closest to the side with the cutout into the mounting hole,
as in Figure 4-13. Make sure to feed the screen under the
lip, as in Figure 4-14.
12 S 4 — A
ection SSembly
Figure 4-10
Figure 4-11
Figure 4-12
& i
nStAllAtion
4. Clip in the other side by pushing the screen into the
provided cutout. See Figure 4-14.
Make sure screen sits
1
under the cover's lip
5. Install the bagger cover onto the bag support assembly, as
seen in Figure 4-15. The plastic cover goes inside of the two
mounting tabs.
Figure 4-13
Figure 4-14
Figure 4-15