Control Panel - Astralpool VAP-2 Manuel D'installation Et D'emploi

Aroma dispenser connection to the equipment on a lower
floor
If the steam equipment is intalled on a floor below the bath, the dispensing
equipment is equipped with a dispensing pump so that the aroma rises to the
steam bath. For the dispenser to opeate correctly, you have to install a
coppler pipe parallel to the steam pipe until it reaches the bath entry pitch so
that the aroma can not go back to the generator though the steam pipe.
15cm copper aroma pipe
tubo de cobre 15 mm aroma
2
9
8
Installation of air outlet pipe
For the air regenration of the bath, an air outlet pipe must be installed. It will
be placed on the ceiling or on the upper part of the wall opposite where the
steam tip is installed.
The outlet pipe must be 90 mm diameter and must be installed with a pitch
towards the inside of the bath so that it does not get plugged by the
condensation of the water steam.
Next, start the equipment by following the control panel instructions for use.
UPPER FLOOR
SUELO PLANTA SUPERIOR
tubo de cobre
15cm copper steam pipe
15m/m para
vapor
O FF C h s h min . C
1
6
A B
7
A B
AB
10

CONTROL PANEL