hestan GABR30-NG Manuel D'utilisation Et D'entretien page 19

GAS CONNECTIONS
GAS CONNECTION - NATURAL GAS (NG)
NOTE: To ensure proper heating performance of this appliance, verify that the gas line supply
pressure is adequate (7.0" WC supply pressure is preferred) to maintain 4.0" WC manifold
pressure. Use a minimum 1/2" ID flex hose to prevent gas starvation. Ensure that the service
pipe supplying the grill is fitted with a shut-off valve conveniently positioned and easily
accessible as an emergency gas shut-off.
Your Hestan grill for use with Natural Gas is supplied with its own regulator which MUST NOT
be removed. If this regulator needs to be replaced, use only the type specified by Hestan for this
appliance.
To connect the regulator / hose assembly follow the next steps:
1. Locate the regulator and gas connection point in the rear right side of your grill (in cart-
mounted models, remove the rear panel to gain access).
2. Install the natural gas regulator as shown. Connect gas supply using a minimum 1/2"
diameter flexible (semi–rigid) stainless steel gas hose, no more than 48" in length. The hose
as well as the connectors must comply with the Standard for Connectors for Outdoor Gas
Appliances and Manufactured Homes, ANSI Z21.75 • CAS 6.27 , and suitable for outdoor
installation. Use the appropriate thread sealant on all connections.
3. Proceed to LEAK TESTING section.
(continued)
©2016 Hestan Commercial Corporation
EN
17