D-Link DCS-6915 Guide D'installation page 9

Configuring Your Camera with the
Installation Wizard
Click on the D-Link Setup Wizard SE icon that was created in your windows Start menu.
the Setup wizard will appear and show the maC address of the dCS-6915 and
an Ip address (which may or may not be correct depending on what you have your
dCS-6915 connected to). If you have a dHCp server on your network, there will be a valid
Ip address displayed here.
Note: A DHCP server is a device that supplies IP addresses to your network devices
automatically.
Your camera's Ip address will be
displayed here along with its
corresponding maC address.
Click the Wizard button
enter the admin Id and password.
Note: The default Admin ID is admin with
the password left blank.
Click Next
Select dHCp if you want to obtain a new Ip
address every time the camera boots up, or
select static Ip to use the same Ip address
at each boot up.
Click Next
00.ff.11.11.66.88
9
192.168.0.20 DCS-6915