Light Fixture Installation - Heath Zenith 4132 Instructions D'installation Et D'utilisation

LIGHT FIXTURE INSTALLATION

For best performance, mount the fixture about 6 feet (1.8 m)
above the ground.
1. Remove two decorative nuts.
2. Remove mounting plate.
3. Tighten mounting screws finger tight.
4. Attach mounting plate to junction box.
Decorative Nut
Ground Screw
Wire Path
Bracket
Mounting
Screws
Note: We recommend having an assistant help hold the
lantern assembly during the wiring process.
208463-03
This fixture comes with a universal mounting bracket. It is
pre-assembled on the fixture to fit the majority of junction
box applications.
If the slots on the mounting plate do not line up with the
junction box screw holes, follow these steps:
1. Remove the fixture mounting screws from the mounting
2. Attach ground wire "pigtail" to ground screw on
3. Flip the mounting plate over.
Mounting Screw
4. Rotate the mounting plate so the wire path is on the
5. Reinstall the fixture mounting screws and attach the
Mounting
Plate
Wire Path
Junction
Box
Mounting Plate
3
plate. Note: Do not remove the ground screw.
mounting plate (See Recommended Grounding Method
for additional information).
upper right. Note: The wire path on the mounting plate
must be located as shown below to allow the wires on
the back of the fixture to pass through.
mounting plate to the junction box as shown.
Ground Screw
Fixture Screws
As Shipped
Wire Path
Flipped and
Rotated