Star ULTRA-MAX 824M Instructions D'installation Et D'opération page 5

LEVELING UNIT
This griddle is supplied with 4 feet or floor stand legs which must be screwed into the body. After the
griddle is in its final position, adjust the legs to create 1/8 inch slant from back to front. This will allow
the grease to run into the grease gutter and provide the proper combustion air for the burners. Adjust-
ing the (4) feet which have an adjustment of 1-3/4" for accurate and perfect line-up with other units.
DO NOT INSTALL WITHOUT ATTACHING FEET OR SUPPLIED STAND LEGS AND
SHELF - DO NOT REMOVE FEET.
CAUTION
Caster Kits: Casters can be used with floor stand
models or optional equipment stand. For installa-
tion, carefully mark and cut off from the bottom of
each leg using a straight cutting saw and de-burr
the inside tube wall prior to installing the caster.
Cut leg should measure 19" tube length, not
overall length. Casters add about 6-1/4" of height
to the unit. Be sure to use approved strain relief
means for protecting gas line connection. If an
appliance is equipped with casters and is gas con-
nected with a quick connect coupling, all personnel
must be aware that there is a restraint on the ap-
pliance and if disconnected for service or cleaning
it must be reconnected as originally installed prior
to use.