Detergent Dispenser; Rinse Aid Dispenser - Danby DDW18D1EW Manuel Du Propriétaire

OPERATING INSTRUCTIONS

DETERGENT DISPENSER

The detergent dispenser must be fi lled before the
start of each wash cycle. Add the detergent just
before starting the wash cycle. Adding the detergent
to the appliance too soon can cause it to become
damp and it may not dissolve properly.
Push the latch to open the dispenser.
Add the recommended amount of detergent to the
main detergent component. The detergent dispenser
has lines on the inside to indicate amounts of
detergent.
If dishes are heavily soiled, extra detergent can be
added to the main cabinet as necessary. Do not use
too much detergent as this can leave a residue on
dishes.
Ensure the detergent dispenser is closed before
closing the door.
The detergent dispenser will always be open and
empty at the end of a wash program.
Detergent tablets may not fully dissolve during a
short program. Only use detergent tablets with
longer programs to avoid residue on tableware.
Always follow the instructions included with the
detergent for best results.

RINSE AID DISPENSER

Rinse aid can be used to prevent water droplets or
streaks from forming on dishes. The rinse aid will be
released automatically during the fi nal rinse. This
dishwasher is designed to use liquid rinse aid only.
Do not use a powdered rinse aid as it will clog the
reservoir opening. Do not put any other substance
in the rinse aid dispenser as this can damage the
dishwasher.
The rinse aid indicator light on the control panel will
illuminate when the rinse aid dispenser is empty.
Fill the dispenser and ensure the lid is closed before
closing the door.
Do not put detergent in the rinse aid dispenser as
this can damage the rinse aid dispenser and leave a
soap fi lm on dishes.
To change how much rinse aid is being dispensed
with every wash, follow the steps below.
1. Turn the dishwasher off.
2. Press and hold the program button.
3. Turn the dishwasher on while still holding the
program button until "rA" appears on the
display.
4. The display will show the current level based on
the chart below. The factory default level is r4.
Press the program button to choose the desired
level.
5. Turn off the dishwasher to confi rm the setting.
Level Dose
r1 no rinse aid
r2 1 dose
r3 2 doses
r4 3 doses
r5 4 doses
5
Note: If the dishes are
not drying properly or
are spotted, increase the
level.
If there are blue stains on
the dishes, decrease the
level.