Lenz Digital plus SILVER direct Mode D'emploi page 26

26 Information SILVERdirect
4.9 Allocating function outputs to the functions of the digital system (mapping)
Here you can define which function of the digital system is used to switch the function outputs A, B,
C and D on or off. The outputs A, B and C can be allocated to function F0 (direction-dependent) or
functions F1 to F8 as desired. Output D can be allocated to function F0 (direction-dependent) or
functions F1 to F12 as desired.
This is allocated in CVs 33 to 46.
4.10 Lighting effect at function outputs
The lighting effect for the function outputs A and B is set in CV60 and for the function outputs C and
D in CV62. If you wish to switch the effects with a function of the digital system, you can make the
allocations to functions F1 to F8 in CV61 (for function outputs A and B) and CV64 (for function
outputs C and D). The effects available are shown in the table of the supported CVs further below.