Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRE-OPERATING INSTRUCTIONS
1.
D
2.
about 10cm away from the wall. Do not place your
damaged by moisture is best.
3.
4.
Make sure the base
E
removing the main unit
lock (
F 2)
D
main unit, position it onto the base then rotate the base
lock counterclockwise to the
FILLING THE WATER TANK
1.
D
2.
Unscrew the tank cap
(F 3). Do not fill with warm or
,
hot water as this may damage the tank and cause
leaking.
3.
tank on the base. The tank will immediately begin to
empty into the base.
4.
Plug the power cord into a convenient electrical outlet.
OPERATING INSTRUCTIONS
1.
.
F
2 status light
will illuminate showing that your
H
2.
Use the high/low button
(
).
(2)
longest run time and quieter performance. It is normal
water and produce a mist.
3.
.
F
4.
The medication cup
J
moisture outlet
.
I
medication into the cup and then turn on your
. D@ N@
cup when the unit is already operating.
IMPORTANT:
I
days, make sure any residual water is drained from the
water tank and base to prevent algae or bacteria growth.
RESET PROCEDURE
When the water tank is empty and the water in the heating
chamber is almost empty, the automatic shut off will
. B
,
. A
.
A
is free of foreign objects by
. To remove, turn the base
K
position until the
.
position.
.
B
,
/
2 (
).
1 (
)
G
(1)
1
,
/
is located near to the
,
. D@ N@
H
:
1.
electrical outlet.
.
2.
,
Maintenance and Filling the Water Tank instructions
the unit.
3.
Allow 15 minutes for the automatic shut off to reset.
4.
After 15 minutes, plug in the unit and switch on your
to produce moisture. If it does not start working, it is
still too hot. Unplug the unit and wait 15-30 additional
minutes, plug the unit back in. The unit should now be
cool enough and operate normally.
CLEANING AND MAINTENANCE
The following maintenance procedures must be routinely
.
.
element and base. It also prevents microorganisms from
growing on the base and tank. This ensures that maximum
We cannot over-emphasize how essential proper cleaning is
to the maintenance and continued use of your unit and the
avoidance of algae or bacteria build-up.
DAILY MAINTENANCE
Allow to cool for 1 hour before maintenance.
1.
electrical outlet.
2.
remove, turn the base lock (
2
position until the main unit can be lifted away from
the base.
3.
E
use.
NOTE: It is imperative that the base is cleaned
properly. The base is also dishwasher safe (top
@NL )
thoroughly before using.
4.
Wipe the heating element
clean with a soft cloth. The element has a coating
that is designed to be easy to clean and prolong
immerse the main unit in water or any other liquid.
D@ N@
. N
glass cleaner, furniture polish, paint thinner or other
5.
.
5
. F
.
.
1
,
,
ILL FAIL
.
F 2)
D
.
. A
and the main unit
C
,
.
Daily
.
.
K
. D@ N@
,
,
.
Publicité
Table des Matières
