Product Care - Remington Power Tools 13A277SF583 Notice D'utilisation

Product Care

Maintenance Schedule
Check/Clean Engine Intake Screens & Cooling Fans *
Check/Clean Exhaust Manifold, Muffler Pipe & Muffler Shields *
Check/Clean Hood/Dash Panel Louvers *
Check/Clean Top & Underside of Deck, Under and Around Spindle
Covers & Belt Area *
Check/Clean Around Fuses, Wiring and Wiring Harnesses *
Check/Clean Around Transmission, Axle and Fans *
Clean Hood/Dash Louvers
Clean Battery Terminals
Lube Front Axles and Rims
Clean Engine Cooling Fins
Lube Pedal Pivot Points
*-- Perform more often in dry conditions and/or when mulching
IMPORTANT: It is important to consult the specific Engine Operator's Manual included with this machine for detailed engine maintenance procedures and intervals.
WARNING! Before performing any
maintenance or repairs, disengage the
PTO, set the parking brake, stop the
engine and remove the key to prevent
unintended starting.
Post-Operation Rider Care
After each operation of the rider, the following
procedures should be implemented to extend
the life of your rider and ensure safe operating
conditions.
WARNING! Failure to follow these
recommendations may result in serious
injury to yourself or others and may
cause damage to the rider.
Cleaning the Underside of the Deck
Refer to the Engine Operator's Manual for all
engine issues and questions.
Smart Jet
Your rider's deck is equipped with a water port
on its surface as part of its deck wash system.
Use the Smart Jet to rinse grass clippings from
the deck's underside and prevent the buildup of
corrosive chemicals. Complete the following steps
AFTER EACH MOWING:
Before Every
Each use 10 Hours
P
P
P
P
P
P
P
P
P
1. Drive the rider to a level, clear spot on your
lawn, near enough for your garden hose to
reach.
CAUTION: Make certain the rider's
discharge chute is directed AWAY from
your house, garage, parked cars, etc.
2. Disengage the PTO, set the parking brake
and stop the engine.
3. Thread the hose coupler (packaged with
your rider's Operator's Manual) onto the
end of your garden hose.
4. Attach the hose coupler to the water port
on your decks surface. See Figure 4-1.
Figure 4-1
Every Every
25 Hours 50 Hours 100 Hours
P
P
5. Turn the water on.
6. While sitting in the operator's position on
the rider, start the engine and place the
throttle lever in the FAST
7. Move the rider's PTO into the engaged (ON)
position.
8. Remain in the operator's position with
the deck engaged for a minimum of two
minutes, allowing the underside of the deck
to thoroughly rinse.
9. Move the rider's PTO into the disengaged
(OFF) position.
10. Turn the ignition key to the STOP
position to turn the rider's engine off.
11. Turn the water off and detach the hose coupler
from the water port on your deck's surface.
NOTE: On 50" and 54" decks there are two
water ports; one on each side of the deck.
12. After cleaning your deck with the Smart Jet
system, return to the operator's position and
engage the PTO. Keep the deck running for
a minimum of two minutes, allowing the
underside of the deck to thoroughly dry.
4
Every Prior
to Storing
P
P
P
P
P
P
P
P
P
P
P
position.
15