Warranty Information - LEMANIA ENERGY LE7.0 Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

OPERATING INSTRUCTIONS

3. If the battery is of the AutoFill type, manufactured by Dagenite or Exide for example, the

glass halls and long filler cap must be left in place during charging.

4. Connect the clamps in the following order

a. First connect the positive clamp (red color) to the positive terminal post.

b. Second connect the negative clamp (black color) to the negative terminal post or to the

chassis remote from the battery and fuel line.

5. Connect the charger to the mains supply, it will turn on, detect the battery voltage, and

start the charging process automatically. If the clamps are incorrectly connected the fault

indicator will illuminate, repeat step 4 correctly.

6. If a mode other than charging is required, press the mode button until the desired mode

is selected. Note: to select the 13.6V continuous supply mode the mode button must be

held for more than 3 seconds when the clamps are not connected to the battery Warning!

Reverse polarity protection is disabled in this mode.

7. If a battery is not fully charged after a maximum of 120 hours, the charger must be

disconnected manually.

8. When the charger is no longer needed disconnect the battery charger from the mains

supply then remove the chassis or negative post connection and finally the positive post

connection. Store the charger safely.

ABNORMALITY PROTECTION FEATURE

If the charger remains in bulk mode for more than 96 hours (105Ah cut-off) then the fault

indicator will illuminate. As with other failure conditions, all other LDS will flash at a 5hz

interval and the charger will output no current. This prevents any damage to the battery.

HSF requirement –RoHS, REACH, 16PAHs<200ppm

Safety requirement –EN60335-2-29, EN60335-1, EN62233 standard for Safety, EN55014-1,

EN55014-2, EN61000-3-2, EN61000-3-3 Standard for EMC test without loading terminal

test.