LEMANIA ENERGY LE7.0 Manuel D'utilisation page 8

b. 24V batteries are compatible with the following modes: Standby, Mode1. The charger
will cycle in this order.
c. Batteries whose voltage lies between 14.6-21V±0.25V may be interpreted as either 12V
or 24V and as such once the mode button is pressed the charging LED will flash at a
frequency of 2±0.2Hz. The processor will analyze the charging trend of the battery in the
following 1-2 minutes. Depending on how the battery reacts it will be identified as either
12V or 24V and then previous charging processes and modes from section a. and b. will be
applicable.
If a battery is not disconnected from the charger once fully charged, the charger will
remain in the trickle charging mode even if the user attempts to change the mode
manually. This protects fully charged batteries from damage.
10. Charging Status Indication
LED 25%
Flashing
ON
ON
ON
ON
11. Memory function
This Smart Battery charger has a unique memory function (not applicable to the 13.6V
Supply and 16V boost mode). The charger returns to last selected mode automatically
when power is switched on after a cut in AC power.
OPERATING INSTRUCTIONS
Please read these instructions carefully before using the smart charger.
1. Before attempting to charge a battery, ensure that the terminals are clean. Remove any
corrosion if present and make sure that any of the removed materiel does not contact the
eyes.
2. Ensure that the area around the battery is well ventilated as explosive gasses may
be released during charging. There must be no sources of ignition, sparking wires, open
flames or other anywhere near the battery.
08
LED 50% LED 75%
OFF OFF
Flashing OFF
ON Flashing
ON ON
ON ON
MODES
LED 100%
OFF
OFF
OFF
Flashing
ON
Charging Status
Under 25%
Under 50%
Under 75%
Under 100%
Fully Charged