Battery Loading & Replacement; I Loading; I Replacement; Connecting And Disconnecting The Headset Plug - Panasonic WX-T3020 Mode D'emploi

Battery Loading & Replacement
Notes:
• Refer to the operating instructions included with the bat-
tery and battery charger.
• Prepare a fully charged battery.
• Battery replacement is recommended when the power
indicator lights up in red and a constant beep is heard in
the headset.

I Loading

Insert the battery as shown in the figure.
Note: Be sure to insert it until the lock clicks.
When inserting the battery, check the
positive and negative sides.

Connecting and Disconnecting the Headset Plug

When connecting the headset plug to this product, hold the
plug and push it straight into the earphone output jack and
microphone input jack.
When disconnecting the headset plug from this product,
hold the plug and pull it straight out.
Pull/insert the plug straight,
holding this part.
Do not hold the cable or pull the plug up and down.
Doing so may cause trouble.

I Replacement

w
1. Slide the battery lock down.
2. Remove the battery.
Do not hold the cable.
Do not pull this
part up and down.
q
9