Changing The Light Bulb; Power Interruptions; Moving Care - Maytag MZF34X20DW Guide D'utilisation

9. Replace the base grille by aligning the ends of the grille with the
leveling assemblies on each side and snapping the grille into
place. Reinstall the screws.
10. Replace all frozen food.
11. Plug in freezer or reconnect power.
12. Set temperature control to desired setting. See "Using the
Control."

Changing the Light Bulb

NOTE: Not all appliance bulbs will fit your freezer. Be sure to replace
the bulb with one of the same size, shape, and wattage.
1. Unplug freezer or disconnect power.
2. Remove the light shield by squeezing the lens from the sides,
pushing back and pulling down.
3. Replace bulb with a 40-watt maximum appliance bulb or LED bulb.
NOTE: LED bulb must be purchased from an authorized dealer.
4. Replace the light shield.
5. Plug in freezer or reconnect power.

Power Interruptions

If the power will be out for 24 hours or less, keep the door closed to
help food stay cold and frozen.
If the power will be out for more than 24 hours, do one of the
following:
Remove all frozen food and store it in a frozen food locker.
If a food locker is not available, consume or can perishable food
at once.
REMEMBER: A full freezer stays cold longer than a partially filled one.
A freezer full of meat stays cold longer than a freezer full of baked
goods. If you see that food contains ice crystals, it may be refrozen,
although the quality and flavor may be affected. If the condition of the
food is poor, dispose of it.

Moving Care

When you are moving your freezer to a new home, follow these steps
to prepare it for the move.
1. Remove all frozen food.
2. Unplug the freezer.
3. Take out all removable parts, wrap them well, and tape them
together so they don't shift and rattle during the move.
4. Clean the freezer thoroughly.
5. Tape the freezer shut and tape the electrical cord to the cabinet.
When you get to your new home, refer to the "Installing Your Freezer"
and "Operating Your Freezer" sections for information on installation
and setting the controls.
9