Some Tips To Preserve The Battery Of Your Bike - URBANGLIDE Bike-100 Pro Mode D'emploi

U
SE THE PRODUCT
1. Choose a suitable place to ride.
2. Open the bike as previously indicated.
3. Press the power button to turn on the bike.
4. Press the switch to turn on the lighthouse.
NOTE: It is important to always light the headlight before using the product. Indeed, the
headlight lights up at the same time as the stop lights. If the headlight is not on, the brake
lights will not work during braking.
5. Make sure you have removed the stand. Sit on the bike and leave your feet on the
ground.
6. Gently press the throttle and place your feet on the footrests, on each side of the
front wheel. Press harder on the accelerator to increase speed.
7. To brake, simply press the brake controls on each side of the handlebars. Press
harder on the brake control to slow down faster.
NOTE: The brake control on the left of the handlebar acts on the front wheel of the bike. The
brake control on the right of the handlebar acts on the rear wheel of the bike.
If you are driving at a high speed, do not brake suddenly with the brake control on the left of
the handlebar, as this may injure you and damage the product.
S
OME TIPS TO PRESERVE THE BATTERY OF YOUR BIKE
Not recommended
This bike is a transportation way that contains a battery.
Acrobatics, jumps, shocks and falls damage the battery. To
maintain the good function over time, it is essential to adapt a safe
and responsible driving.
The bike is not completely waterproof (IP54). Avoid puddles larger
than 4 cm that can immerse the battery and motor, and damage
them.
:
7