How To Use - URBANGLIDE Bike-100 Pro Mode D'emploi

H
OW TO USE
F
OLD THE PRODUCT
1. Before folding your bike, make sure to put the kickstand.
2. Lift the latch safety and pull it at the same time.
3. Lower the handlebar on the right side and fold down the latch.
D
EPLOY THE PRODUCT
1. Screw the foot pegs on each side of the front wheel.
2. Lift the latch, then raise the handlebar until it reaches its initial position.
3. Fold down the latch. You will hear a "click" when the latch is closed and the safety
lock is engaged.
4. You can now use the product safely.
L
OAD THE PRODUCT
1. Make sure the charging connector is clean and dry.
2. Start by plugging the switch into the power interface, then plug the other end of
the charger into the bike.
3. When the red indicator lights up on the charger, it means that the charging is done
correctly, if it is not the case, check that the line is connected correctly.
4. When the LED on the charger changes from red to green, the battery is fully charged.
Stop loading. Charge time too long could affect the life of the battery.
6