Instructions Of Buttons - URBANGLIDE RIDE 100 PRO Notice Originale

Fault display
Battery level

Instructions of Buttons

1- Switch: long press the power button to turn on/off the power;
2- Acceleration: press the right acceleration button to start and accelerate;
3- Brake: hold the brake handle to brake.Lightly step on the rear fender to assist the
brakes
4- Short press the function key to directly adjust the speed
•
• Beginner mode: no characters in the gear position
• Normal mode: gear characters display white
• Sports mode: gear characters display red
•
5- Headlights: Press the function button twice shortly to turn on the headlights, and the
taillights are
always on; In the light-on state, press the function button twice shortly to turn off the
headlights and taillights
6- Cruise mode: keep the current speed for 6 seconds to enter the cruise mode
7- Exit the cruise mode when pressing accelerator again or brake
Pre-assembly instructions
1. Pull up the lever while
pressing down the rear wheel
fender.
Speed
Function
Speed level
Unit display
8
3. Fix the brake lever with
M5 hex wrench.