Connect The Cables - Axis P7214 Guide D'installation

AXIS P7214 Installation Guide
2. Drill the four mounting holes.
3. Insert the provided wall plugs into the wall, and attach it to the wall using the screws provided.

Connect the cables

1. Connect the encoder to the network using shielded network cables. If using PoE see note below.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 8 for information
on the terminal connector pins.
3. Optionally connect active speakers and/or external microphones.
4. Connect the cameras to the video inputs.
5. If powering the unit with DC input, connect the supplied indoor power adapter or an external
power supply. See note below.
6. Check that the indicator LEDs indicate the correct conditions. See the table on page 10 for
further details.
Note:
The unit can be powered using either the DC power input or PoE (Power over Ethernet). If powering the
unit using DC power, connect the power supply to the power connector at the rear of
the unit. If powering the unit using PoE, connect a PoE network cable.
Access the product
AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from www.axis.com/techsup
The product can be used with most operating systems and browsers. The recommended browsers
are
• Internet Explorer® with Windows®
• Safari® with OS X® and
• ChromeTM or Firefox® with other operating systems.
For more information about using the product, see the User Manual available at www.axis.com
Page 7