CABASSE L-OCEAN Notice D'installation page 21

1. Select the «on» position for the
2a
speakers. Press the power button: the Lissajous curves
on the bases of the loudspeakers are illuminated, the system is
ready for use without CRCS room adaptations.
2. Switch the required playback component on. The DAP will
select and display it automatically.
3. If several playback components are connected and ready to
play, scroll down or up the list using the SELECT button of the
DAP or the rotating ring of the remote and choose the compo-
nent you want to use.
CABASSE ROOM COMPENSATION SYSTEM (CRCS) SETUP
1. Press the «FUNCTION» button (1) on either the DAP or the
remote control and then select CRCS.
2. Press «SELECT» or to confirm the launch of the measure-
ments procedure.
3. Connect the measurement microphone in the «Set Up mic»
socket located in the back plate of the DAP.
B 1 2
4. Enter the measured distance between the tweeters of both
loudspeakers with the SELECT 4
1 .
START AND PLAY
4. No source connected: connect and switch on the expected
a5 switch of both loud-
source component.
5. The source being played last is not detected: switch it on.
6. Adjust the sound level with the 6 VOLUME potentiometer
of the DAP or the 6 «+» and «-» keys of the remote control.
5. Start of the measurement process: see the schemes page 6 for
the microphone positions.
6. First measurement: place the microphone 1 meter away from
the tweeter in front of the right loudspeaker and validate on
PUSH or
following measurements. Note that the volume level can not be
modified until the validation of last CRCS measurement.
7. KEEP SILENT! the system first measures the room noise, then
calibrates the sound level for the next measurements.
5 knob and validate with
. The software will calibrate the sound level for the