Jula Meec tools 016366 Mode D'emploi page 36

EN
3. Tighten the nut firmly anticlockwise with
the two supplied spanners.
FIG. 25
CLEANING
• Keep the ventilation openings on the
product clean.
• Blow clean the inside of the motor
housing with compressed air after use to
remove dust. The accumulation of dust
can cause overheating and damage the
product.
• Clean the outside of the product when
necessary with a soft, damp cloth. Do not
use solvent. Make sure no liquid gets into
the product. Never immerse any part of
the product in water or any other liquid.
NOTE:
The manufacturer cannot accept liability for
personal injury and/or material damage
resulting from unauthorised repair or
improper use.
TROUBLESHOOTING
It is not possible to tighten the
knob for the depth setting.
The support wheel arm is not correctly placed
in one of the three setting for the trimming
depth. Move the support wheel arm up or
down to one of the three settings and tighten
the knob.
The product does not start
Check that the product is correctly connected
to the power supply. Press in the power switch
lock and then press the power switch to start
the product.
36