Remote Control Features And Settings; Fan Speed - GE Caliber Serie Manuel Du Propriétaire

Remote Control Features and Settings

Remote Control
7
8
2
3
10
9
16
12
17
13
1. Power Button
Press the ON/OFF button on the remote control to start
or stop the unit.
2. COOL Button
In COOL mode, the unit operates in cooling. When FAN
is set to AUTO, the heat pump automatically adjusts the
fan speed according to the room temperature. The
be displayed during COOL mode.
3. HEAT Button
In HEAT mode, warm air will blow out after a short period
of the time due to cold-air prevention function. When FAN
is set to AUTO, the heat pump automatically adjusts the
fan speed according to room temperature. The
displayed during HEAT mode.
4. Temperature +/- Buttons
4
Temp + : Every time the button is pressed, the
temperature setting increases. Temp - : Every time the
button is pressed, temperature setting decreases. The
operating temperature range is 60°F-86°F (16°C-30°C).
5. FAN SPEED Button
FAN SPEED: For each press the fan speed changes as
follows:
Remote control:
6. DRY Button
1
DRY mode is used to reduce humidity. In DRY mode,
when room temperature becomes lower than temp.
setting +2°F, unit will run intermittently at LOW speed
6
regardless of FAN setting. The
DRY mode.
4
7. FAN MODE Button
FAN mode circulates air only; there is no temperature
adjustment available. Use the fan speed button (5) to
11
adjust fan speed from low, medium to high. Auto, Turbo
and Quiet are not available.
5
8. TURBO Button
The TURBO function is used for fastest air flow in
14
Heating or Cooling modes. Control will display the
TURBO icon [UP ARROW] on the bottom right side of the
remote display. Pressing the TURBO button again or the
15
FAN SPEED button will turn TURBO off.
19
9. Quiet Button
The QUIET function switches the fan to the lowest speed.
18
The control will display the QUIET icon [DOWN ARROW]
on the bottom left side of the remote display. Pressing the
QUIET button again or the FAN SPEED button will turn
QUIET off.
10. Louver UP/DOWN Button
Press the LOUVER UP/DOWN button to choose the
position of the horizontal airflow louvers.
Status display of air flow
COOL/DRY:
will HEAT:
NOTE:
• It is advisable not to keep the vertical louver in the
downward position for an extended period of time in
COOL or DRY mode, otherwise condensate water may
form on the louver.
will be • When turning the unit on, the remote control will
automatically return the louver to the previous set swing
position. When turning the unit off, the louver will rotate to
the full open position prior to closing.
will be displayed during
49-5000277 Rev. 0