Configuration Options - IKUSI TAL-800 Serie Mode D'emploi

1.4 - CONFIGURATION OPTIONS

The amplifier has 4-pin and 2-clip configuration links. The first ones determine the configuration by
their orientation (0, 45 or 90°) when are plugged in the sockets, and the second ones by their site in a
group of pins on the main board (ALSC/RW/INGRESS group).
The available configuration options are described below and the involved links are identified (see
Block Diagrams on page 13 and Fig. 1 on page 32):
1.4.1 - Forward Way Configuration
— RF Input. The positioning of 2 plug-in links (PE1 and PE2) allows to configurate the ampli-
fier without input bypass or with input bypass at -2.7 dB or -4.5 dB.
— Attenuation. The positioning of 2 plug-in links (PAF and PAA) provides different input atte-
nuation values (between 0 and 15 dB if additional preamplification is not implemented, or
between 0 and 6 dB if it is).
— Equalization/Cable Simulation. The positioning of 1 plug-in link (PSC) together with a
built-in variable equalizer allows to adjust an input equalization between -6 and 18 dB.
(The negative equalization, or reverse equalizer response, is usually necessary in short spa-
ced amplifiers).
— FW additional amplification. The positioning of 1 plug-in link (PAA) allows to implement
or not a 10 dB preamplification stage.
— Sloped Response. The positioning of 1 plug-in link (PPB) provides 0, 6 or 12 dB sloped
response.
— RF Output. The positioning of 2 plug-in links (PS1 and PS2) allows the amplifier to be
configurated with one RF putput port or two symmetrical or asymmetrical output ports.
1.4.2 - Reverse Way Configuration
— Interstage attenuation. The appropriate positioning of 2 plug-in links in the ALSC/RW/
INGRESS group allows to configurate a 0 or 6 dB interstage attenuation.
— Disabling. Other positioning of the same plug-in links allows to disable the return path.
1.4.3 - 'FW Input Test' Port Performing
Appropriate positioning of the mentioned PE1 and PE2 plug-in links allows the internal RW
output test to become transformed in a FW input test port.
1.4.4 - Power Configuration
Appropriate positioning of 4 plug-in links (S
red models, the RF port from which the power is directed to the power supply, as well as its
passing to other RF ports. For the mains powered models, these links determine simply the
passing between ports for a possible remote current.
, S , S and S determines, for the line powe-
A B C D)
15