Shindaiwa EC741s Manuel D'utilisation page 22

Before you start
Adjusting the wheel guard angle
Never operate the machine without the wheel guard in place.
1. Wheel guard
2. Wheel guard knob
Reverse mounting the cutter arm
1. Guard stopper
2. Screw
1. Nozzle
1. Locking knob
WARNING
3. Wheel guard locking
knob
3. Pipe connector
4. Pipe
2. Wheel guard knob
1. The wheel guard can be adjusted to prevent debris from fly-
ing off and hitting the operator.
2. Turn the wheel guard locking knob counterclockwise, grasp
the wheel guard knob and move the wheel guard to the de-
sired position, then slowly release it and secure the wheel
guard with the locking knob.
∗ Never operate the machine without the guard stopper in place.
When shipped the cutting wheel is mounted so it is near the cent-
er of gravity of the machine. The cutting wheel can be moved to
a position outside the machine by reverse mounting the cutter
arm.
Reverse mounting the cutter arm compromises the bal-
ance of the machine and makes it difficult to operate. Do
not use it in the reversed state except when necessary.
1. Remove the cutting wheel.
2. Remove the 2 screws and remove the guard stopper.
3. Remove both of the pipes connected to the pipe connector.
Remove the pipe connector after removing the nut mounted
on the wheel guard.
4. Mount the pipe connector in the lower hole in the wheel
guard.
5. Loosen the nut that holds the nozzle in place.
6. Remove the wheel guard knob mounted on the wheel cover.
7. Remove the nut of the locking knob and reinstall it after
changing the angle of the knob.
20
WARNING