Vertical Discharge - Broan Elite E64000 Serie Instructions D'installation

6. CHOSE THE OPENING(S)
Remove the knockout for the chosen opening(s) (horizontal at the back of the hood or vertical on top). See illustrations below.
V
ERTICAL DISCHARGE
H
ORIZONTAL DISCHARGE
NOTE: For ducted installation only.
Punch out the appropriate electrical knockout hole on top (A) or back (B) of
the hood. Install the wire clamp (included in parts bag).
NOTE: For a non-ducted installation, punch out the back electrical
knock-out (B).
7. HORIZONTAL DISCHARGE INSTALLATION
All internal blower hoods are factory shipped with the blower(s) mounted for a vertical discharge configuration. For a horizontal discharge
configuration, disassemble the blower(s) from the inner top of the hood and mount it (them) to the back panel of the hood. The procedure
below applies for one or two motors.
Unplug the blower.
Using a 5/16" socket, remove all blower mounting
screws from the inner top of the hood. Keep the
screws for further use.
(INTERNAL BLOWER HOODS ONLY)
1
1
HR0021
(INTERNAL BLOWER(S) ONLY)
HE0085
L S M
EFT IDE
S L
CREWS
HD0269
9
2
2
A
HR0024
OUNTING
OCATION
3
3
B
R S
IGHT IDE
M S
OUNTING CREWS
L
OCATION
HD0282