Troubleshooting - Klarstein DELOREAN Mode D'emploi

Replacement light
Max.
Ø
Power
70 mm 1.5 W
33,2 mm
1.5 W
x 120 mm

TROUBLESHOOTING

Problem
Light on, but motor does
not work.
Both light and motor do
not work.
Oil leakage
Voltage Picture
DC 12 V
DC 12 V
Cause
The blades are blocked.
The capacitor is damaged.
The motor is damaged.
The internal wiring of
the motor is cut off/
disconnected.
An unpleasant smell may
be produced.
Apart from the above mentioned, check the following:
The light is damaged.
The power cord is loose.
Outlet and the air
ventilation entrance are
not tightly sealed.
The connection of the
U-shaped section and the
cover is leaking.
ILCOS D
code
DSR-
1.5-S-70
DSS-1.5-
S-33.2
/120
Solution
Check the blades.
Replace the capacitor.
Replace the motor.
Replace the motor.
Replace the lights.
Connect the wires as
shown in the electric
diagram.
Take down the outlet and
seal with glue.
Take the U-shaped section
down and seal it with a
suitable material.
EN
41