Troubleshooting - Klarstein VALERIA BRILLIANT EDITION Mode D'emploi

EN
34

TROUBLESHOOTING

Note: Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact costumer service if in any doubt before undertaking any
of the below. Always disconnect the unit from the power source when opening the
unit.
Fault
Light on, but motor does
not work
Light does not work, motor
does not work.
Light is not working
Oil leakage
Insufficient suction
The range hood inclines.
Possible Cause
Fan switch turned off.
Fan switch failed
Motor failed.
House fuses blown.
Power cord loose or
disconnected.
Lamp is damaged.
One way valve and
the outlet are not tightly
sealed
Leakage from the
connection of chimney
and cover
The distance between the
range hood and the gas
top is too far.
The fixing screws are not
tight enough.
Solution
Select a fan switch
position.
Contact costumer service.
Contact costumer service.
Reset/Replace fuses.
Refit cord to power outlet.
Have the lamp replaced
(as described in this
manual).
Take down the one way
valve and seal with
sealant.
Take chimney down and
seal.
Refit the range hood to the
correct distance.
Tighten the hanging
screws and align the
range hood horizontal.