Maintenance And Care - Uline H-1036 Mode D'emploi

With machine switched on, tape loaded and water in
reservoir:
1. For preset lengths of tape: Press the numbered key
that corresponds to the desired length.
2. Add 2" to preset lengths. For example, to make a 10"
length of tape: First, push the +2 key (light comes
on), then push the '8' key. Dispenser makes a 10"
length of tape. Push the +2 key again to turn off
this feature.
3. For custom tape lengths: Press and hold the
green "Random Length" key until the desired length
is dispensed.
PROGRAMMING TWO LENGTHS OF TAPE
You can program the dispenser to memorize one or two
different tape lengths with the Short Length and Long
Length keys.
NOTE: Programmed keys must be reset each
time the dispenser is switched on.
1. Set Short Length: While holding down the Short
Length key, press the number key that corresponds
to the shorter length desired. Release both keys to
set the short length.
2. Set Long Length (second length): while holding
down the Long Length key, press the number key
that corresponds to the longer length desired.
Release both keys to set the long length.
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WARNING! Burn Danger – Switch off power,
unplug the dispenser and allow the top heater
to cool down before performing any cleaning,
maintenance or repair.
WEEKLY MAINTENANCE
1. Wash the moistening brush with soap and warm
water. Rinse thoroughly with water.
2. Clean the dispenser using compressed air (NEVER
WATER) to clean off dust and dirt.
MONTHLY MAINTENANCE
1. Lubricate the cutting blades with a drop of oil.
2. Clean the rubber tape advance wheel with water.
DO NOT grease or oil the wheel. Access the wheel
by removing the upper paper guide.
PAGE 5 OF 20
OPERATION
3. Use the Short Length key to dispense your shorter
4. Slide the color-coded sliding indicators next to the
PROGRAMMING INTERMEDIATE LENGTHS OF TAPE
Use this procedure to dispense intermediate lengths of
tape (example, 18" or 22" lengths).
1.
2. Follow Steps 1-4 in "Programming Two Lengths of Tape."
USING THE TOP HEATER
Use the top heater in cold conditions or with particular
types of paper tape. Heats up within 3 minutes.
1.
2. Switch heater OFF. Press the thermometer icon key
WHEN DISPENSER IS NOT IN USE
Always switch power off and unplug dispenser.

MAINTENANCE AND CARE

3. Clean the water reservoir with soap and water.
4. Clean only the outside of the heater (close to the
5. To remove bigger deposits, use a very fine abrasive
6. Replace the heater if deposits cannot be removed
HEATER CLEANING
length and the Long Length key to dispense the
longer length.
number keys to mark your two chosen lengths.
Press the +2 key (indicator light is on). This adds 2" to
any preset number key you choose.
Switch heater ON. Press the thermometer icon key
(light comes on).
(light goes out).
Rinse thoroughly.
brush) with a cloth dipped in decalcifying product.
cloth or thin blade– Do not scratch or damage the
surface.
or after 3,500 hours of use.
WARNING! Burn Danger - Switch off power,
unplug the dispenser and allow the top heater
to cool down before attempting to clean
the heater.
CAUTION! NEVER use water or liquid to clean
the top heater.
0122 IH-1036