Electrical Connection; Function - Caso Germany D10 Mode D'emploi

• Do not set up the device in a hot, wet or extremely damp environment
or near flammable material.
• Do not cover up any openings on the device and do not block these off.
• The electrical socket must be easily accessible so that the power lead
can be disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup
locations (e.g. on ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the safe use
of this device.

11.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the
following instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage
and frequency) on the rating plate with those of your electrical network.
This data must agree in order that no damages occur in the device
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may
employ a 3 meter long (max.) extension cable with a cross-section of
1.5 mm². The use of multiple plugs or gangs is prohibited because of
the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been
installed under the ice maker or over hot or sharp surfaces.
• The electrical safety of the device is only guaranteed if the device is
connected to a properly installed protective conductor system.
Operations using an electrical outlet without a protective conductor are
prohibited. If in doubt, have the house installation checked over by a
qualified electrician.
The manufacturer cannot be made responsible for damages that are
caused by a missing or damaged protective conductor.

12 Function

In this chapter, you'll find important information on the function of the
device.
Caso D10 30