Warnings; Installation - Physipro SC7550 Manuel D'utilisation

WARNINGS

•
Physipro Inc. protector pads are reserved exclusively for use on mobility aids
(manual or power wheelchairs).
•
Never push or lift wheelchair with the protector pad, doing so may cause the
pad to detach from the wheelchair which may result in damage or injury.
Always lift wheelchair with the rigid parts of the frame.
•
The protector pad should be tested before prolonged use. To avoid redness
due to pressure points, it is necessary to regularly check for redness in the
various critical pressure areas, especially around bony prominences.
•
Before use, let the protector pad get to room temperature to limit discomfort
caused by excessively hot or cold surfaces.
•
Avoid exposing the protector pad to extreme cold or heat and avoid
prolonged contact to fluids or moisture. Never place near open flame.
•
Crash tests have not been conducted on this product and even if the mobility
aid in which it is installed has obtained the ISO-717619, it will not be
maintained.

INSTALLATION

1. Unfasten the snap button A.
Pull belt through the fixed loop B.
2.
3. Position the protector pad as desired.
Fasten snap button A.
4.
A
4
Protector pad
B