Recommendations; Warnings - Physipro APPUIS-THORACIQUES AU LIT Manuel D'utilisation

RECOMMENDATIONS

Before use, verify the quality and condition of the In bed thoracic support system's
components.
To ensure your bed system provides optimal protection and comfort and to
extend your product lifespan, the following precautions should be applied.
• The In bed thoracic support system must be installed on a mattress of no
more than 38" (96 cm) in width. Mattress surface must be clean before
installation.
• Inspect the system weekly to ensure velcro fabric and the thoracic supports
are well adjusted.
• Before use, let the thoracic supports and Velcro fabric get to room
temperature to limit discomfort caused by excessively hot or cold surfaces.
• Remove any foreign object (crumbs, debris, etc.) from thoracic supports and
velcro fabric surfaces.
• Clean on a regular basis and visually and all components of the in bed
thoracic support system periodically.
• Never place thoracic supports or velcro fabric near sharp object.
• The components of the in bed thoracic support system should be stored
on a flat surface, in a dry area and out of direct sunlight.
It is recommended to consult your therapist in the month following the
installation of the bed system to make sure it is efficient.

WARNINGS

Consult a healthcare professional: Physipro
care professional
positioning, be
system and make any necessary adjustments.
Positioning: The proper positioning of the in bed thoracic support system
is essential to ensure maximum comfort.
Environment:
moisture for prolonged periods. Avoid exposing the bed system to extreme
cold or heat. Never place near open flame.
such as a
consulted to
Avoid exposing component of the bed system to fluid or
4
In Bed Thoracic Support
recommends that a health
TM
doctor or therapist, experienced in
install the in bed thoracic support