Lanaform Aroma Design Mode D'emploi page 7

Breakdown
No vapour and no indicator light
The vapour has an unusual smell
Low intensity
ADVICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed
of at your local sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a
paper recycling bin. The packaging film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with
the law.
LIMITED WARRANTY
LANAFORM® guarantees this product against any material or manufacturing defect for a period of two years from the
date of purchase, except in the circumstances described below.
The LANAFORM® guarantee does not cover damage caused as a result of normal wear to this product. In addition, the
guarantee covering this LANAFORM® product does not cover damage caused by abusive or inappropriate or incorrect use,
accidents, the use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort,
that is outside LANAFORM®'s control.
LANAFORM® may not be held liable for any type of circumstantial, indirect or specific damage.
All implicit guarantees relating to the suitability of the product are limited to a period of two years from the initial date of
purchase as long as a copy of the proof of purchase can be supplied.
On receipt, LANAFORM® will repair or replace your appliance at its discretion and will return it to you. The guarantee
is only valid through LANAFORM®'s Service Centre®. Any attempt to maintain this product by a person other than
LANAFORM®'s Service Centre will render this guarantee void.
The photographs and other images of the product in this manual and on the packaging are as accurate as possible, but
do not claim to be a perfect reproduction of the product.
Possible causes
If there is no light.
The water level in the tank is too
low.
The top for adjusting the power
of the vapour is not in the correct
position.
The cable passes above the
transducer.
The water tank is leaking.
The temperature of the device is
too low.
The water has been in the tank too
long.
Too much/little water in the tank.
Sediment on the transducer.
The water is too cold.
The water is unclean.
Remedies
Check that the device is plugged in
and that there is not a problem with
the mains supply.
Add water to the tank.
Reposition it correctly.
Reposition it correctly.
Check that the rubber stopper is
positioned correctly.
Place the device in the room at
room temperature for half an hour
prior to use.
Clean the tank and fill with fresh
water.
Empty/fill the water tank.
Clean the transducer.
Use water at room temperature.
Clean the tank and fill with fresh
water.
Aroma Design
EN
7