Skil 4480 Consignes De Fonctionnement/Sécurité page 11

RIP FENCE AND CIRCLE CUTTING GUIDE
This accessory is available at an extra cost. It
is used for fast and accurate straight and
circle cutting (Fig. 15).
ATTACHING RIP FENCE
1. Insert bar of rip fence through the slots
provided in foot, from either side of foot with
the edge guide facing down (Fig. 15).
2. Thread the clamp screw from under the foot
through the threaded hole in the clamp on left
side of foot, and securely tighten clamp screw
with a screwdriver, to clamp the rip fence bar
in place.
STRAIGHT CUTTING
Once the rip fence is attached, measure from
the edge of work to the line of cut, and set edge
guide of rip fence to the same distance and
then securely
(Fig. 16).
CIRCLE CUTTING
1. Before attaching the rip fence, draw a circle
and drive a finishing nail in the center of circle.
2. Drill or plunge cut near the circles edge,
turn saw off and disconnect the plug from
power source (Fig. 17).
3. Attach rip fence to saw with the edge guide
facing UP. In order for the rip fence to cut a
circle, the nail must be in alignment with the
blade, as shown in (Fig. 18).
4. Measure the distance from the selected
hole to the blade to be equal to the circle
radius.
5. Insert plug into power source, hold the saw
firmly, squeeze trigger and slowly push the
tighten clamp
FIG. 15
CLAMP
CLAMP
SCREW
EDGE GUIDE DOWN
FIG. 16
CLAMP
SCREW
LINE
OF CUT
screw
FIG. 17
WEDGE
EDGE
GUIDE UP
-11-
SLOT
BAR
DESIRED
WIDTH
FINISHING
NAIL