Carefully read all instructions before operating the appliance and save them for future
reference. By carefully following these instructions you can considerably prolong the
service life of your appliance.
The safety measures and instructions contained in this manual do not cover all possible
situations that may arise during the operation of the appliance. When operating the
device the user should be guided by common sense, be cautious and attentive.
IMPORTANT SAFEGUARDS
• The manufacturer is not responsible for injuries
caused by failure to comply with the safety require-
ments and operation rules of the appliance.
• This appliance is intended to be used for non in-
dustrial use in household and similar spheres of
application. Industrial application or any other
misuse will be regarded as violation of proper
service conditions. Should this happen, manufac-
turer is not responsible for possible consequences.
• Before plugging in the appliance ensure that the
circuit voltage matches operating voltage of the
appliance (see the technical specifications or the
manufacturer' s plate on the appliance).
• Use an extension cord designed for the power
consumption of the appliance: the mismatch in the
parameters may cause the cable to short-circuit or burn.
4
• Connect the appliance only to grounded outlets – this
is a mandatory electrical safety requirement. Using an
extension cord, make sure it is also grounded.
• Unplug the appliance after use and when cleaning
or moving it. Remove the cord with dry hands, hold-
ing it by the plug, not by the wire.
ATTENTION! During the operation, the appli-
ance heats up! Be careful! Do not touch the
appliance body while it is operating. To avoid
burning with hot steam, do not lean over the
appliance when opening the lid.
• Use the appliance only for its intended purpose. Use
of the device for purposes other than those specified
in this manual is a violation of the operating rules.
• It is allowed to use the kettle with the stand pro-
vided with the appliance only.
• Do not extend the power cord in doorways or near
heat sources. Make sure that the cord is not twist-
ed or bent, not in contact with sharp objects, cor-
ners and edges of furniture.